6. - Connect all the cables and the cards of expansion. Pay special attention to the feeding connector: in the ancient badges Baby-AT it is divided in two pieces, so that the black cables must remain faced in the center; in the modern badges ATX the position of the connector, only one, it is given by the form of his contacts.

Align the red stripe of the cables of diskette and hard disk with the pin number 1 of the corresponding connector, which position will be indicated by a child "1" and/or an arrow serigrafiados in the motherboard; do all this with the manual of the badge at sight and following his indications exactly.

Do not forget to connect the cables for connection of the source ATX, reset, leds of ignition, turbocharger (this one of little or no utility) and hard disk, etc., as well as the warning screen of the speed in MHz if it exists (again completely incidental, but resultón), in addition to the connector of the internal loudspeaker or speaker.

7. - Without closing the box, verify everything again, connect the feeding and the monitor, pray if it is believing (you forgive for the irreverence, but any help is small in this point) and light the computer.

Pay attention to possible strange whistles (continued, in leaps and bounds...), as well as in view of the hard disk and the disk drive and to the screen of the monitor, I hope salt the typical messages of the BIOS or it remains black; observe also if the fan of the mike turns.